Linksys Velop WiFi mesh systems are well known to provide blazing-fast internet throughout the home. But as every technical device gets stuck with some technical issues, so is the case with the Linksys Velop extenders as well. Linksys Velop red light is one such issue that is occurring with almost every Linksys Velop user. But it is no daunting task to get the issue resolved. You need to follow a few troubleshooting steps and get rid of the red light instantly. If you are also troubled by this issue, then walk through the instructions given ahead. For your information, some of the hacks in this article will need you to access the Linksys extender login page, so keep the login details ready.
Linksys Velop Red Light Issue: Resolved
-
Power Cycle Linksys Velop
Sometimes the red light issue is due to technical hitches which can be handled by a simple power cycle process. Are you wondering what a power cycle is? Read the instructions below and power cycle your Linksys Velop:
-
Get near your Linksys Velop and turn its power button off to cut the power supply.
-
Disconnect it from the wall electrical outlet.
-
Also, disconnect any other cable that is connected to it.
-
You need to wait for some time now. Maybe for a minute.
-
Connect all the cables as they were earlier.
-
Plug the power adapter back into the wall socket.
-
Toggle the power button to the on position now. The power supply is working again. The LEDs will flicker and then get settled.
The instant the device is powered up completely, check if the red light has bid you goodbye. If it still is lingering around, then try the next hack.
-
Bring Extender Closer to Router
A red light on the Linksys Velop indicates a poor internet connection. So we should focus on fixing this now. The Linksys Velop extender should be placed within the router’s range so that it can receive an optimum signal from the router. Thus consider bringing the extender closer to the router. However, do not place them too close either. This will enhance the issue further.
-
Check Power Supply
You now need to make a check on the power cable that is connected to the Linksys Velop extender to supply power to it. Perhaps it is loose. So check the power cable. The extender should be receiving an optimum power supply. But if the power adapter is not plugged in properly, then this is far from happening. It is recommended to plug the cable properly and also check the power socket that it is plugged into. If you find any damage on it then plug the extender in some other socket that is active and not damaged.
-
Alter the Connection Mode
The Linksys extender connects to the host router and receives a signal from it. If you have connected both devices using a wireless medium then there are chances of signal loss. What you need to do here is alter the mode of connection. That means change from wireless to wired connection. For that, you got to opt for an Ethernet cable but it should be in very good condition. There is no point in choosing a damaged or worn-out cable. Isn’t it? So get your hands on an Ethernet cable and insert its ends into the Ethernet ports of the router as well as the Linksys Velop extender. With a solid and firm connection between the devices, the red light issue is bound to say goodbye.
Reset Linksys Velop
If none of the above given troubleshooting hacks have helped you, then you should reset your VElop now. Perhaps there is something major that your device is stuck with. Or maybe there is something wrong with its configuration. So, reset it right away and restore the factory settings. After this, set it up again. If you have no idea how to setup Linksys Velop then check the user manual that you got along with the device during purchase.
Conclusion
So, this is all about how you can get rid of Linksys Velop red light issue in easy steps. We are very much hopeful that the Linksys Velop red light issue is no more troubling you.